Comdial FX Series Specifikace stáhnout pdf (Strana 245)

VMMI Programming Exercises

GCA39-082 Rev 2, Issue 9/01 Page 14 Printed in the USA

Testing the Setup

Task Expected Results

1. Restore the database to the switch (optional).

2. Plug a 25 pair cable from the IST board to the

Loop Start Line board.

This will allow you to test the Line Group 1 access

from 1002 and 1003.

3. Press a group intercom button on Ext. 1002. You will get intercom dial tone and see the button

light up green. You will see it light up red at Ext

1003. Hang up.

4. Press a group intercom button on Ext. 1003. You will get intercom dial tone and see the button

light up green. You will see it light up red at Ext

1002. Hang up.

5. Busy out Ext. 1002’s intercom key. From Ext.

1001 call Ext. 1002.

The call will come in on the first group intercom key

(4101) if your Intercom Hunt List is programmed

correctly. The call should also ring.

6. Press the LNG1 button on 1002 and 1003

You will access a line in Line Group 1. This allows

you to make out-going calls.

Exercise Review

• The Hybrid mode is a PBX-like arrangement.

• Hybrid mode is used most often when there are more system lines than buttons on the

telephones

• In Hybrid mode you can add Park keys and Page to enhance call handling.

• You may set Hybrid mode when master clearing the database. You may also reprogram your

database to this arrangement

• Hybrid mode:

* Has no direct line appearances

* Uses group intercoms as “ call keys” to handle calls

1 2 ... 240 241 242 243 244 245 246 247 248 249 250 251 252

Žádné komentáře

Comdial FX Series Specifikace Strana 245